Loading/Removing The Instax Square Film Pack; Loading The Film Pack; Unloading A Used Film Pack - FujiFilm instax Square SQ 20 Guide D'installation

Loading/Removing the INSTAX SQUARE Film Pack

Caution
Do not open the film door until you have used up
the film; otherwise, the rest of the film is exposed
and turns white and the film can no longer be used.
• When you load the film pack, never press the two
rectangular holes on the back of the film pack.
• Never use a film pack beyond its shelf life; otherwise, it
may damage the camera.
Use FUJIFILM Instant Film "instax SQUARE" only.
The instax mini film or instax WIDE film cannot be used.
Notes on the film pack
• Each FUJIFILM Instant Film "instax SQUARE" pack contains
1 black film protective cover and 10 film sheets.
• Only remove the film pack from its inner bag just before
inserting into the camera.
• The film cover is ejected automatically when the film
door is closed. The camera works to eject a film even
though the film pack is not loaded.
For details, refer to the instructions and warnings on
FUJIFILM Instant Film "instax SQUARE".

Loading the Film Pack

~
2
1
Press and hold the button of the film door lock (1),
then slide the lever to the right (2) until the film
door opens slightly.
Ÿ
2
1
Hold both sides of the
film pack, align the
bottom of the film pack
on the groove of the film
chamber (1), then insert
it straight (2).
!
⁄

Unloading a Used Film Pack

When no film is left, all dots on the right of the shooting
screen are displayed in gray. (Page 19)
Unload the film pack.
~
2
1
Press and hold the button of the film door lock (1),
then slide the lever to the right (2) until the film
door opens slightly.
Ÿ
Close the film door. Make
sure the film door lock
clicks into place.
The film cover (black) is
ejected automatically when
the film door is closed.
Remove the film cover from
the film ejection slot.
Grasp the rectangular
holes on the film pack,
then pull it out straight.
13
EN