11.1 Ambient conditions
12.
Disposal
13.
Distributor in the US/Contact in Canada for product
information and complaints
1.
Applicable to
►
For item-specific instructions for use and information on material
compatibility,
see
www.extranet.bbraun.com
2.
Safe handling
CAUTION
Federal law restricts this device to sale by, or on order of a physician!
►
Remove the transport packaging and clean the new product, either
manually or mechanically, prior to its initial sterilization.
►
Prior to use, check that the product is in good working order.
►
To prevent damage caused by improper setup or operation, and in order
not to compromise warranty and manufacturer liability:
– Use the product only according to these instructions for use.
– Follow the safety information and maintenance instructions.
– Only combine Aesculap products with each other.
►
Ensure that the product and its accessories are operated and used only
by persons with the requisite training, knowledge, or experience.
►
Keep the instructions for use accessible for the user.
►
Only use handpieces and tools expressly approved for the HiLAN power
system.
also
the
Aesculap
15
3.
Product description
15
3.1
Components required for operation
15
When putting the HiLAN XS pneumatic motor into operation, the follow-
ing components are required
Designation
Compressed-air sup-
Extranet
at
ply with a minimum
of 6 bar (0.6 MPa)
Compressed-air tubes Aesculap Dräger system GA464 (3 m),
Foot control
HiLAN XS pneumatic
motor
Hi Line XS handpiece
Special features
Art. no.
If compressed air is sup-
Pressure reducer:
plied via a compressed-
e.g., GA099
gas cylinder, use a pres-
sure reducer
GA466 (5 m)
If needed, extension
tubes GA194 (3 m),
GA195 (5 m)
DIN connection
GA461 (3 m, with
diffuser)
GA463 (3 m, with-
out diffuser)
GA465 (5 m, with-
out diffuser)
If needed, extension
tube GA087 (5 m)
Motor tube
GA513 (3 m)
GA523 (2.3 m)
GA505 (5 m)
If needed, extension
tubes GA194 (3 m),
GA195 (5 m)
GA521
3