Bleeding And Checking The Filter System - Steinbach Comfort 50 Notice Originale

1. Screw the INTEX pools
adapter clockwise onto the return line
on the valve head
2. Screw one hose end clockwise onto
the adapter of the return line.
3. Connect the second end to the
connection on the injection nozzle of
the pool.
The return line is connected.
33
Connecting the backflush line
A rubber stopper is inserted in the connector of the backflush line
factory. If you are not using the backflush line (e.g., when using filter balls as
the filter medium) you can leave this stopper in to protect the device from
dirt and insects entering the system.
1. Pull the rubber stopper out of the connector of the backflush line
head .
1
2. Connect one hose end to the connector of the backflush line
3. Guide the second hose end towards the channel connection.
The backwash line

Bleeding and checking the filter system

1. Press and hold down the valve lever
2. Set the valve lever to the "RÜCKSPÜLEN" (BACKFLUSH) position and release it.
3. Allow the filter vessel
backflush line
4. Check the filter system and the connections for leaks.
In the case of leaks, wrap extra Teflon tape around the affected connections.
5. Backflush the system (see "Backflushing" section).
return line
22
.
1
is connected.
34
to fill with water until the water runs out of the "WASTE"
6
.
34
15
33
16
on the valve head
35
34
on the valve
34
.
34
.
1
1
22
33
22
33
22
at the
59