Mounting The Pump On The Base Plate; Hose Connections - Steinbach Comfort 50 Notice Originale

Mounting the pump on the base plate

1. Insert the threaded screws of the
screw set for fastening the pump
from below into the two hexagonal
holes in the base plate
2. Place the pump
so that the threads protrude
9
through the fastening opening in the
pump base.
3. Push the washer and then the serrated
lock washer over the screw thread.
4. Put on one winged screw each and tighten it.
The pump is mounted on the base plate.
5. Connect the base plate
vessel .
6
The base plate is connected to the filter
vessel.

Hose connections

- Fasten all attached hose connections with hose clamps to ensure that the system
does not leak.
We recommend additionally sealing the hose connections with Teflon tape.
- Use suitable pool hoses for the described connections.
Some hoses, such as the pressure hose, are very stiff. Place them in the sun
before use so that the heat makes them more flexible.
56
23
.
9
on the base plate
10
to the filter
9
8
10
9
9
6
9
8
23