Care Instructions; Maintenance; Backflushing - Steinbach Comfort 50 Notice Originale

Stopping the pump operation
To stop the pump operation, press the ON/OFF button
deactivated only by disconnecting the pump from the power supply.

Care instructions

The filter system cannot filter out algae, bacteria and other microorganisms.
- Use special water care substances to prevent and remove these to ensure
hygienically clean water.
- Consult an expert and observe the dosage.

Maintenance

Backflushing

Backflushing regenerates the filter and the filter sand. The filter sand must cleaned prior
to the initial start-up and in regular intervals while in use.
Do not backwash when using Steinbach Filter Balls. If the filter throughput
decreases, we recommend washing the filter balls by hand. If necessary,
exchange the filter balls.
1. Press the ON/OFF button
2. Connect the backwash line (see section "Connecting the backwash line").
3. Press and hold down the valve lever
4. Set the valve lever to the "RÜCKSPÜLEN" (BACKFLUSH) position and release it.
The level engages at the "Rückspülen" (Backflush) position.
5. Press the ON/OFF button
6. Backwash the system until clean water emerges from the backwash line (max. 2
minutes).
7. Press the ON/OFF button
8. Press and hold down the valve lever
9. Set the valve lever to the "NACHSPÜLEN" (RINSE) position and release it.
The level engages at the "Nachspülen" (Rinse) position.
10. Press the ON/OFF button
11. Let the pump run for 20 to 30 seconds to remove any residue in the valve head.
12. Press the ON/OFF button
The valve head is still in the "Nachspülen" (Rinse). Make sure that to set the valve
head to the desired position, e. g., "Filtern" (Filter), after reactivating the pump.
The backwashing is completed.
to switch off the pump
38
on the valve head
35
to switch on the pump
38
to switch off the pump
38
on the valve head
35
to switch on the pump
38
to switch off the pump
38
. The timer function can be
38
.
10
.
1
.
10
.
10
.
1
.
10
.
10
61