Operation; Selecting The Mode; Pump Operation - Steinbach Comfort 50 Notice Originale

Operation

A damaged device or damaged accessories may cause injuries.
- Check the device and the accessories (see section "Testing").

Selecting the mode

1. Press the ON/OFF button
off the pump
2. Press and hold down the valve lever
on the valve head
3. Turn the valve lever to the desired
position and let go.
The level engages at that position.
The desired mode is set.

Pump operation

Information on how the timer function works can be found in the "How the timer
works" section
Starting the pump operation
Check the valve stetting of your filter system before you activate the pump.
1. Connect the pump's power plug to the power supply.
The running time display is lit. If a battery is inserted, the last selected running time is
displayed.
2. Press the timer button
lit.
3. Press the ON/OFF button
The pump will now run nonstop for the selected running time. The timer function
activates the pump again at the same time on the following day.
The pump is running. Listen if the pump makes any unusual noises. If there is air in the
system, bleed it again.
60
Risk of injury!
to switch
38
.
10
.
1
several times until the LED of the desired running time is
37
to switch on the pump
38
CAUTION!
17
35
35
10
.