Filtering Time; Operation With Floor Cleaner - Steinbach Comfort 50 Notice Originale

Example: 6 hours running time
1. Connect the pump's power plug to the power supply.
The running time display is lit.
2. Press the timer button
3. Press the ON/OFF button
The pump now runs for 6 hours nonstop. If you pressed the ON/OFF button at 12 PM,
for instance, the filter system runs until 6 PM.
The timer activates the pump again at 12 PM.
Example: external timer
To use this mode a battery must be inserted and you need an external timer (not
included in the package contents).
4. Connect the timer to the power supply and set the desired running times.
The timer must not supply power to the pump.
5. Connect the pump's power plug to the timer.
The running time display is lit. If the display is not lit, the timer is inactive. Read the
operating instructions of the timer.
6. Press the timer button
The 24-hour setting indicates continuous operation.
7. Press the ON/OFF button
The timer now controls the running times of the pump.

Filtering time

The pool's water content should be turned over at least three to five times in 24 hours
depending on the use and the size of the system. The operating time depends on the
output of the filter system and the pool size.

Operation with floor cleaner

Use a skimmer with a screen basket or similar device if your filter system
does not feature a prefilter to prevent foreign objects from damaging the
device.
Observe the instruction manual notes of the floor cleaner. Air must not
penetrate the filter system to prevent the system running dry and
overheating.
You can connect the hose of the floor cleaner directly to the suction line of the filter
system. The hose of the floor cleaner must be completely filled with water.
52
several times, until the LED "6" is lit.
37
to switch on the pump
38
several times, until the LED "24" is lit.
37
to switch on the pump
38
.
10
.
10