Filter Shaft; Description Of The Filter System - Steinbach Active Balls 50 Notice Originale

Filter shaft

A filter shaft is required if the pool is partially or entirely installed in the
ground so you can place the pump of the filter system below the pool's
water level.
- Make sure that the filter shaft cannot be flooded and that ambient and rainwater can
drain away easily.
You can do so by installing a gravel layer at the bottom of the shaft. An optional
immersion pump with a float switch that is connected to a canal or drain additionally
protects your filter system from rising water inside the shaft.
- Ensure sufficient natural ventilation of the shaft to prevent condensation.
- Design the size of the filter shaft so that you can carry out work on the filter system.

Description of the filter system

Description of the filter system
The filter balls in the filter vessel
Contaminated pool water passes through the suction line
filter pump and the filter cover
10
When the water flows through the filter balls, dirt particles are deposited and filtered out
of the water.
The cleaned water flows through the filter cover in the return line
If the manometer
and must be cleaned.
42
1
serve as a dirt and floating debris filter.
6
1
on the filter cover rises above 1 bar, the filter balls are very dirty
20
A
B
A
Modell:
040120
385 mm
040220
385 mm
, from the top into the filter vessel.
C
B C
635 mm
615 mm
380 mm 615 mm
of the pool, through the
25
back into the pool.
27