Filter Shaft; Description Of The Filter System; Modes Of The Filter System - Steinbach Classic 310 Notice Originale

Filter shaft

A filter shaft is required if the pool is partially or entirely installed in the
ground so you can place the pump of the filter system below the pool's
water level.
- Make sure that the filter shaft cannot be flooded and that ambient and rainwater can
drain away easily.
You can do so by installing a gravel layer at the bottom of the shaft. An optional
immersion pump with a float switch that is connected to a canal or drain additionally
protects your filter system from rising water inside the shaft.
- Ensure sufficient natural ventilation of the shaft to prevent condensation.
- Design the size of the filter shaft so that you can carry out work on the filter system.

Description of the filter system

Modes of the filter system

Your filter system has several modes. They are indicated by numbers on the valve head.
1. Filter
2. Rinse
3. Circulate
4. Backflush
5. Closed
6. Drain
7. Winter
The individual modes are described below.
1
B
Modell:
040310
040340
C
A
A B
310 mm 605 mm
665 mm
365 mm
C
525 mm
555 mm
47