Stopping - Emergency Stopping; Emptying The Dust Container; At The End Of A Cleaning Session - Nilfisk ALTO ATTIX 200 Mode D'emploi

Stopping - Emergency stopping

Push the stop button "H" (Fig. 4).

Emptying the dust container

DANGER !
– Before proceeding with these operations, turn off the
vacuum cleaner and remove the plug from the power
socket.
– Check the class of the vacuum cleaner.
Before emptying the container it is advisable to clean the filter
(see par. "Shaking the primary filter".)
A. Versions for dust harmful to health: M - H classes suitable
for vacuuming hazardous and/or carcinogenic dust (H
class).
DANGER !
– These operations can only be carried out by trained
and qualified personnel who must wear adequate
clothing, in compliance with the laws in force.
– Take care not to raise dust when this operation is
carried out. Wear a P3 protective mask.
– In case of dangerous and/or toxic dust, use the plastic
bag (code 40100).
– Use a safety container if asbestos is to be vacuumed.
Therefore, in this case, the vacuum cleaner must be
equipped with our ABS safety container (code 8 30202
- 8 31365 Fig. 10) in order to dispose of the dust.
– The container and/or bag must only be disposed of by
qualified personnel and in compliance with the laws in
force.
11/2008
How to replace the safety container:
– Place the vacuum hose in a safe and dust-free place;
– Release the dust container "I" (Fig. 10);
– Close the safety container with the supplied cover, remove
it from the dust container "I" (Fig. 10), and replace it with
an empty one.
– Start the motor again to prevent dust from being blown
about.
– Make sure that the seal is in perfect condition and correctly
positioned.
– Switch off the motor, fit an empty container in place and
fasten it in position.

At the end of a cleaning session

1. Turn off the vacuum cleaner and remove the plug from the
socket.
2. Wind the connection cable (Fig. 11).
3. Empty the container as described in the "Emptying the
container" paragraph.
Clean the vacuum cleaner as described in the
"Maintenance, cleaning and decontamination" paragraph.
5. Wash the container with clean water if aggressive
substances have been vacuumed.
6. Store the vacuum cleaner in a dry place, out of reach of
unauthorized people.
7. Shut the inlet with the appropriate plug "A" (Fig. 11) when
the vacuum cleaner is transported or not being used
(particularly in the case of M - H versions).
9
ATTIX 200
I
GB
F
D
E
C329