Melitta CAFFEO SOLO & milk Mode D'emploi page 28

Fault
Coffee only flows drop-by-
drop.
Coffee does not flow.
The grinder is not grinding.
Loud grinder noise
Bean symbols
flashing although the bean
container is full.
The symbol is illuminated
without a reason.
The cleaning or descaling
process was interrupted.
Not enough milk froth is
formed during the frothing
process.
The brewing unit can no
longer be reinserted after
removal.
The symbols for cleaning
and stand-by
alternately.
Continuous flashing of all
buttons
28
BA_Solo_Milk_082016.indd 28
Troubleshooting
Cause
Grinding fineness is too fine.
Water tank not filled or
incorrectly inserted.
Brewing unit is obstructed.
The beans are not falling into
the grinder.
Foreign objects in the grinder.
Foreign objects in the grinder.
are
Insufficient quantity of ground
beans in the brewing chamber
There is air in the lines inside
the appliance.
The power supply was
interrupted, e.g. due to a power
outage.
The nozzle of the steam pipe is
in the wrong position.
The steam pipe nozzle is dirty.
The brewing unit is not properly
locked.
The actuator is not in the
proper position.
The brewing unit is missing or
not properly inserted.
flash
The brewing chamber is
overfilled.
System error
Measure
Adjust the grinding fineness more
coarse.
Clean the brewing unit.
Perform a descaling or cleaning
programme if necessary.
Fill the water tank and make sure it is
inserted correctly.
Clean the brewing unit.
Tap lightly on the bean container.
Call the hotline.
Call the hotline.
Press the button or
button.
Turn the valve switch 11 clockwise
until the stop until water flows out of
the appliance.
Clean the brewing unit if necessary.
The appliance performs a rinsing
program autonomously. To do
so, follow the instructions on the
appliance.
Adjust to the proper position.
Clean the nozzle.
Check whether the handle for locking
the brewing unit is correctly engaged.
Switch the appliance off and then on
again. Press the and
buttons simultaneously for longer than
2 seconds. The actuator is put into
position. Then reinsert the brewing
unit and make sure it is correctly
locked into place.
Insert the brewing unit properly.
Switch off the appliance and switch
it on again using the ON/OFF button
(repeat if necessary) until standby
mode is displayed.
Switch off the appliance and switch it
on again via the ON/OFF button
; if this does not solve the problem
send the appliance to the service
department.
21.09.2016 07:23:15