Melitta CAFFEO SOLO & milk Mode D'emploi page 21

Preparing milk froth and heating
milk and water
Warning!
There is a risk of burn injuries and
scalding due hot steam and the hot
steam pipe.
– Never reach into the escaping steam.
– Avoid direct skin contact with hot water
and the hot steam pipe.
– Never touch the steam pipe during
use or immediately after use.
The steam pipe is used to prepare milk
froth, to heat milk or to dispense hot water.
Preparing milk froth
If possible, use cold milk with a high
protein content.
• Switch on the appliance.
• Push the outer shell of the steam pipe
down in the direction shown by the
arrow (Image K, 1).
• Press the button.
the appliance is heating up. After the
heat-up phase,
• Fill the vessel with milk to maximum one
third.
• Hold the vessel under the steam pipe.
In doing so, ensure that the tip of the
steam pipe is immersed in the milk.
• Turn the valve switch 11 clockwise until
the stop. is flashing. The hot steam
froths the milk and heats it up.
• Turn the valve switch 11
counterclockwise until the stop. The
frothing is completed.
• Rinse the steam pipe after each use.
BA_Solo_Milk_082016.indd 21
flashes while
is illuminated.
Heating milk
• Switch on the appliance.
• Push the outer shell of the steam pipe
up in the direction shown by the arrow
(Image K, 2).
• Fill a vessel with milk.
• Hold the vessel under the steam pipe.
In doing so, ensure that the tip of the
steam pipe is immersed in the milk.
• Press the button.
the appliance is heating up. After the
heat-up phase, is illuminated.
• Turn the valve switch 11 clockwise until
the stop. is flashing. The hot steam
heats up the milk.
• Turn the valve switch 11
counterclockwise until the stop. The
heating is completed.
• Rinse the steam pipe after each use.
Rinsing the steam pipe
The steam pipe should be cleaned at
regular intervals ("Cleaning the steam
pipe", page 23).
• Switch on the appliance.
• Fill a vessel halfway with clear water.
• Hold the vessel under the steam pipe.
In doing so, ensure that the tip of the
steam pipe is immersed in the water.
• Press the button.
the appliance is heating up. After the
heat-up phase, is illuminated.
• Turn the valve switch 11 clockwise until
the stop. Close the valve again after
5 seconds. The steam pipe has been
rinsed.
• Wait for 30 seconds or press the
button to change to the normal operating
mode.
flashes while
flashes while
21
21.09.2016 07:23:14