Melitta CAFFEO SOLO & milk Mode D'emploi page 22

Dispensing hot water
A maximum of 150 ml of hot water can be
dispensed in each process. To dispense
a larger amount of hot water, repeat the
process.
• Switch on the appliance.
• Push the outer shell of the steam pipe
up in the direction shown by the arrow
(Image K, 2).
• Hold the vessel under the steam pipe.
• Turn the valve switch 11 clockwise until
the stop. is flashing. Hot water will
flow into the vessel.
• Turn the valve switch 11
counterclockwise until the stop.
Water hardness and filter
It is important to properly set the water
hardness so that the appliance displays
the need to be descaled in due time. From
the factory, it is set at water hardness 4.
After inserting a Melitta
filter, it is automatically set at hardness
level 1.
®
Melitta Claris
The Melitta Claris
®
lime and other harmful substances from
the water. The water filter should be
changed every 2 months, however, at the
latest when appears on the display.
The water filter is available in specialised
shops.
Inserting the water filter
flashes during the entire changing
process.
• Put the water filter in a glass with
tap water for several minutes before
inserting it in the appliance.
• Switch off the appliance.
22
BA_Solo_Milk_082016.indd 22
Claris water
® ®
®
water filter
water filter removes
®
• Press and hold the
for approx. 3 seconds, then release.
appears on the display.
• Empty the drip tray and insert without
the coffee grounds container.
illuminates.
• Pull the water reservoir 7 up and out of
the appliance.
• Empty the water reservoir.
• Screw the water filter onto the thread at
the bottom of the water reservoir.
• Fill the water reservoir with fresh tap
water up to the max. mark.
• Insert the water reservoir into the
appliance. illuminates.
• Place the coffee grounds container
under the steam pipe 12.
• Turn the valve switch 11 clockwise until
the stop. flashes on the display.
Water will flow into the vessel.
• When is illuminated on the
display, turn the valve switch 11
counterclockwise until the stop.
• The appliance is ready for operation.
and illuminate. The water hardness
is automatically set to hardness level 1.
• Empty and insert the coffee grounds
container.
After inserting the water filter, the water
can be cloudy during the first rinse
because excess activated carbon is
washed out of the filter. The water will then
be clear clear again.
and buttons
21.09.2016 07:23:14