Panasonic AJ-YA350G Guide D'installation page 2

ENGLISH
CAUTION:
These servicing instructions are for use by qualified service personnel only. To reduce the risk of fire or
electric shock do not perform any servicing other than that contained in the operating instructions
unless you are qualified to do so.
1
Make sure the power of AJ-HPX2000/2100 is
turned off.
2
Unscrew 6 screws on the right side of AJ-
HPX2000/2100 (on the right as viewed from
the front side) to remove the side panel.
3
Disconnect the cable in No. 3 CAMDSP1
board and then remove the CAMDSP1 board.
4
Unplug the cable connecting AJ-HPX2000/
2100 to the CAMDSP1 board, from the JK101
connector.
2
Screws
Cable
CAMDSP1
board
JK101
connector
5
Insert the CAMDSP1 board into its original
position. In this operation, ensure that the
cable removed in Step
slot.
6
Connect the cable removed in Step
CAMDSP1 board.
7
Connect the cable removed in Step
JK101 connector of AJ-YA350G. In this
operation, the cable must be caught in the
clamp.
8
Insert AJ-YA350G into a vacant Slot In this
operation, ensure that the cable connected in
7
Step is not caught in the slot.
9
Return the side panel to the original position
and fix it by using the screws.
For details about operation, see the operation
manual of the camera recorder.
4
is not caught in the
3
to the
4
to the
Clamp
JK101
connector