Selecting The Output Modes ("Set Menu" Mode); Function Description; Center Speaker - Yamaha RX-V995 Mode D'emploi

Selecting the output modes ("SET MENU" mode)

The following functions control the output signals to the speakers in your audio system. When speaker connections are all
completed, select a proper position on each function to maximize the performance of your speaker system.
* For details about the SET MENU mode, refer to pages 56 to 59.

Function description

1. CENTER SPEAKER

Choices: LARGE (LRG)/SMALL (SML)/NONE
Preset position: LRG
LRG: When your center speaker is approximately the same
size as the main speakers.
SML: When you use a center speaker that is smaller than
the main speakers.
In this position, low bass signals (below 90 Hz) at the
center channel are output from the SUBWOOFER
terminals (or the main speakers if the MAIN position
is selected on "4. LFE/BASS OUT").
NONE: When you do not have a center speaker.
The center channel sound will be output from the left
and right main speakers.
1. CENTER SPEAKER
2. REAR SPEAKER
3. MAIN SPEAKER
4. LFE/BASS OUT
5. MAIN LEVEL
2. REAR SPEAKER
Choices: LARGE/SMALL
Preset position: LARGE
LARGE: If your rear speakers have a high ability for bass
SMALL: If your rear speakers do not have a high ability for
reproduction, or a subwoofer is connected to the rear
speaker in parallel.
In this position, full range signals are output from the
rear speakers.
bass reproduction.
In this position, low bass signals (below 90 Hz) at the
rear channels are output from the SUBWOOFER
terminals (or the main speakers if the MAIN position
is selected on "4. LFE/BASS OUT").
PREPARATION
29