Plugging In This Unit - Yamaha RX-V995 Mode D'emploi

Plugging in this unit

• After completing all connections, plug the AC power cord
into an AC outlet.
NTER
AL FOR CORRECT SETTING.
(*1):
AC OUTLET(S)
(U.S.A., Canada, China, Singapore and General models)
.......................................................... 2 SWITCHED OUTLETS
(Australia model).................................. 1 SWITCHED OUTLET
Use these to connect the power cords of your components to
this unit.
The power to the SWITCHED outlets is controlled by this unit's
STANDBY/ON switch or the remote controller's SYSTEM
POWER ON and STANDBY keys. These outlets will supply
power to any connected unit whenever this unit is turned on.
The maximum power (total power consumption of components)
that can be connected to the SWITCHED AC OUTLET(S) is
100W.
IMPEDANCE SELECTOR
SPEAKERS
REAR SET BEFORE POWER ON
( SURROUND )
CENTER : 6ΩMIN. / SPEAKER
REAR : 6ΩMIN. / SPEAKER
MAIN
A OR B : 4ΩMIN. / SPEAKER
A B : 8ΩMIN. / SPEAKER
CENTER : 8ΩMIN. / SPEAKER
REAR : 8ΩMIN. / SPEAKER
MAIN
A OR B : 8ΩMIN. / SPEAKER
A B :I6ΩMIN. / SPEAKER
A
B
(General model)
• Unplug the AC power cord from the AC outlet if this unit is
not to be used for a long period of time.
VOLTAGE SELECTOR
AC OUTLETS
SWITCHED
I00W MAX. TOTAL
(*1)
(*2):
Voltage Selector (China and General Models
only)
The voltage selector on the rear panel of this unit must be
set for your local main voltage BEFORE plugging into the
AC main supply.
Voltages are 110/120/220/240 V AC, 50/60 Hz.
PREPARATION
To AC outlet
(*2)
27