Supplementary Notes - Parkside PTS 20-Li A1 Traduction Des Instructions D'origine

e) Do not use a toothed or chainsaw blade or
a segmented diamond-coated disc with more
than 10 mm wide slits. These kinds of accesso-
ries often cause a kickback or loss of control
over the power tool.
f) Avoid cutting disc jams or excessive contact
pressure. Do not make any excessively deep
cuts. Overloading the cutting disc increases the
stress and likelihood of tilting or blocking and
thus the possibility of a setback or a breakage
of the grinding tool.
g) If the cutting disc jams or you stop working,
switch the tool off and hold it steady until the
disc has completely stopped turning. Never
attempt to pull a rotating cutting disc out of a
cut. This could lead to kickback. Identify and
remove the cause of the jam.
h) Do not switch the power tool back on as long
as it is in the workpiece. Allow the cutting disc
to reach its full speed before you carefully
continue the cut. Otherwise, the disc may jam,
jump out of the workpiece or cause kickback.
i) Support panels or large workpieces to re-
duce the risk of the cutting disc jamming and
causing a kickback. Large workpieces can
bend under their own weight. The workpiece
must be supported on both sides, namely in the
vicinity of the cut and also at the edge.
j) Be particularly careful when making pocket
cuts into existing walls or other obscured
areas. The inserted cutting disc may cut into
gas or water pipes, electrical wiring or other
objects that can cause kickback.
PTS 20-Li A1

Supplementary notes

WARNING!
Protect yourself from laser radiation!
LASER
P max.: < 1 mW • λ: 650 nm •
EN 60825-1:2014
This appliance contains a Class 2 laser.
► Never direct the laser beam at people or
animals.
► Never look directly into the laser beam.
The laser beam can cause serious eye
damage.
► Do not direct the laser beam at strongly
reflective material. Reflected laser beams are
also dangerous.
► Any adjustment intended to increase the
intensity of the laser beam is forbidden.
There is a risk of injury!
► No liability will be accepted for damage
resulting from manipulation of the laser
equipment or from disregarding these safety
instructions.
► Caution! If using operating or adjusting
devices other than those specified here or if
carrying out other procedures, this may result
in hazardous radiation exposure.
CAUTION!
► If using operating or adjusting devices other
than those specified here or if carrying out
other procedures; this may result in hazard-
ous radiation exposure.
NOTE
■ If the appliance is not used in accordance
with the manufacturer's operating instructions,
the intended protection may be impaired.
2
GB │ IE │
31 ■