Removal - Renkforce AN-8006 Notice D'emploi

Masquer les pouces Voir aussi pour AN-8006:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

Protect your CD tuner against vibrations with the bolt at the back of the unit. In most vehicles, such a safety
fastening is provided for. If this is not the case in your car, fasten the CD tuner with the enclosed punched metal
strip. For the fastening, proceed as follows.
When you have made all the electrical contacts (see "Electric Connection") insert the CD tuner into the frame until
it locks in.
Replace the frame cover of the front control panel.
Keep the two unlocking keys. You will need them for a later removal of the CD tuner.

Removal

Remove the front control panel.
Carefully remove the plastic frame in the front of the system, by bending it slightly to the outside and pulling it off
from the unit.
Insert the two unlocking keys into the lateral slots between the CD tuner and the installation frame, until the CD
tuner unlocks.
Remove the fastening screw at the back of the unit.
Carefully pull out the radio with the unlocking keys from the installation frame.
Disconnect all connectors from the device
56
Operating Instructions
English

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

37 19 35

Table des Matières