Menu Settings - Renkforce AN-8006 Notice D'emploi

Menu settings

Volume control / dial control (23)
In standard operation, the volume control / dial control (23) is for setting the volume. Press the control or the button
SEL/ENT (30) on the remote control once or several times, to change the parameters BAS (bass control), TRE (treble
control), BAL (balance control) and FAD (fader control) by turning the control.
To select further functions, first press the volume control/dial control (23) or the button SEL/ENT (30) on the remote
control a little bit longer (>2 seconds), and then press this button once more, but only very briefly, until the desired
function appears on the display:
Choose the options for the respective settings by turning the volume control/dial control (23).
TA SEEK/ALARM
TA SEEK: When the radio has lost the traffic information, it will seek a new station with Traffic Announcement
coding.
TA ALARM: There will be an alarm signal when the TA code cannot be received any more.
MASK DPI/ALL
MASK DPI: Automatic switchover to the best receivable frequency of the selected station chain only if
RDS signals are transmitted there as well.
MASK ALL: Automatic switchover to the best receivable frequency of the selected station chain, also if
RDS signals are not transmitted here as well.
TAVOL
TAVOL 00-46: Set the desired volume volume for the traffic reports here. The higher the set value, the louder
the playback of the report.
RETUNE S/L
RETUNE S: When the radio does not receive traffic announcements any more, the auto-scan starts 60
seconds later.
RETUNE L: When the radio does not receive traffic announcements any more, the auto-scan starts 90
seconds later.
65