Removal - Renkforce CD-7630 Notice D'emploi

Protect the device against vibrations using the bolt at the back of the unit.
Most vehicles are already equipped with such a safety fastening. If this is not the case in your car, fasten the device
with the provided punched metal strip.
To fasten the device, proceed as illustrated below:

Removal

• Remove the front control panel.
• Carefully remove the plastic frame from the front of the device by bending it slightly outwards and pulling it off
the device.
• Insert the two unlocking keys into the lateral slots between the device and the installation frame until the device
is unlocked.
• Remove the fastening screw at the back of the device.
• Carefully pull the car radio out of the installation frame with the unlocking keys.
• Disconnect the ISO plug, the aerial plug and the LINE connections.
46
Operating Instructions

English