Renkforce AN-8006 Notice D'emploi page 80

Establishing/disconnecting an already saved connection
Establishing the connection:
• Press the button 0/Band (20) for 2 seconds.
• During the connection process, the display (3) shows CONNECT and in case of a successful connection CONT
OK afterwards.
• If NO CONT appears, the connection process was not successful. In this case, try to repeat the pairing procedure.
Terminating the connection:
• Press the button 0/Band (20) for 2 seconds.
• The display (3) shows NO CONT > the connection was terminated.
Establishing a telephone connection
• Press the button
• Select the desired phone number with the numerical buttons (9, 10, 11, 12, 13, 14, 16, 17, 18 and 20).
• The dialled number appears on the display (3).
• Press the button
• Press the button

Press the button
Redial
• Press the button
• Press the button
• Press the button
80
(22) to access telephone mode.
(22) again to dial.
/AMS (21) to terminate the call.
/AMS (21) while entering the phone number to make corrections.
(22) to access telephone mode.
(22) again to call up the last phone number.
(22) again to dial.
Operating Instructions

English