Operating Elements And Connections; General Safety Notes - Monacor International IMG Stage Line LSX-40G Mode D'emploi

Please unfold page 3. Then you can always see the
GB
operating elements and connections described.

1 Operating Elements and Connections

1 Mounting bracket
2 Setscrew (2 ×) for the mounting bracket
3 Power indication
4 Indication BEAT: shortly shows blue when a sound of
sufficient volume is picked up by the microphone (10)
to control the laser beam
5 Operating buttons
Button FUNC to select a function
Buttons DOWN and UP to change the DMX start
address when the display shows the address
Button ENTER to memorize a function
6 Display
7 DMX signal output (3-pole XLR) for connection to the
DMX input of another DMX light effect unit;
pin 1 = ground, 2 = DMX-, 3 = DMX+
8 DMX signal input (3-pole XLR) for connection of a
light controller;
pin 1 = ground, 2 = DMX-, 3 = DMX+
9 Control for the response sensitivity in case of music
control via the microphone (10)
10 Microphone for music control
11 Key switch according for the laser protection adviser:
the laser beam cannot be switched on with the key
removed
12 Mains jack for connection to a socket (230 V~/50 Hz)
via the supplied mains cable
13 Support for the mains fuse
Only replace a blown fuse by one of the same type
14 Mains switch on / off
8
2 Safety Notes
The unit corresponds to all required directives of the EU
and is therefore marked with
2.1 Notes especially for class 3b laser
This laser corresponds to the class 3b and has the fol-
lowing power and wavelength:
Model Max. Laser Power
LSX-40G 40 mW
LSX-80R 80 mW
LSX-120RG 40 + 80 mW
WARNING 1. The unit must be installed so that no -
body will be able to look directly into the
laser beam. Already a short radiation on
the retina may cause permanent dam-
age. Unintentional reflections must be
prevented.
2. The laser area must be limited and marked during
operation.
3. A laser protection adviser must be appointed in writ-
ing and be present during operation (regulation BGV
B2 of the employerʼs liability insurance).
4. The operation of the laser must be notified at the
employerʼs liability insurance association and the
trade board.

2.2 General safety notes

WARNING The unit is supplied with hazardous mains
voltage (230 V~). Never make any modifi-
cation on the unit and do not insert any-
thing through the air vents! This may
cause an electric shock hazard.
It is essential to observe the following items:
G
The unit is suitable for indoor use only. Protect it
against dripping water and splash water, high air
humidity, and heat (admissible ambient temperature
range 10 – 40 °C).
G
Do not set the unit into operation, and immediately dis-
connect the mains plug from the mains socket if
1. there is visible damage to the unit or to the mains
cable,
2. a defect might have occurred after a drop or similar
accident,
3. malfunctions occur.
The unit must in any case be repaired by skilled per-
sonnel.
G
Never pull the mains cable to disconnect the mains
plug from the mains socket, always seize the plug.
G
For cleaning the housing only use a dry, soft cloth,
never use water or chemicals.
G
No guarantee claims for the unit and no liability for any
resulting personal damage or material damage will be
accepted if the unit is used for other purposes than
.
Laser Wavelength
532 nm (green)
650 nm (red)
650 nm (red) + 532 nm (green)