Operating Elements And Connections; Applications; Setting Into Operation - Monacor International Stase Line DIB-102 Mode D'emploi

GB Please unfold page 3. Then you can
always see the operating elements and
connections described.
1 Operating Elements and
Connections
(for channel 1 only,
channel 2 is identical)
1 XLR output jack, bal.
2 Groundlift switch
3 Input jack, unbal.
4 Parallel feedthrough jack, unbal.
5 Slide switch to attenuate the input signal
2 Important Instructions for Use
The unit corresponds to all required direc-
tives of the EU and is therefore marked
with .
G
The unit is suitable for indoor use only.
Protect it against dripping water and
splash water, high air humidity, and heat
(admissible ambient temperature range
0 – 40 °C).
G
Only use a dry, soft cloth for cleaning.
Do not use any chemicals or water.
G
No guarantee claims for the unit and no
liability for any resulting personal dam-
age or
accepted if the unit is used for other pur-
poses than originally intended, if it is not
correctly connected, operated, or not
repaired in an expert way.
If the unit is to be put out of operation
definitively, take it to a local recycling
plant for a disposal which is not
harmful to the environment.
6
material damage

3 Applications

The DI Box (Direct Injection) serves for
optimal connection of a musical instru-
ment with high impedance, unbalanced
output to a low impedance, balanced input
of a mixer (figure 2). By means of the bal-
anced connection to the mixer, interfer-
ence can be avoided in case of long con-
necting cables as well. In case of prob-
lems
connection between instrument and mixer
can be separated by means of the
groundlift switch. Then the devices are
d.c. separated.
High signal levels can be reduced by
means of the attenuator and can be
adapted to the mixer input. Thereby, the
DI Box can also be connected directly to
the speaker output of an instrument ampli-
fier. Consequently, the effect on the sound
by the amplifier (e. g. guitar or tube ampli-
fier) will be maintained at the mixer input.

4 Setting into Operation

The DI Box does not need any power sup-
ply. In the text below, only channel 1 is
described. Setting into operation of chan-
nel 2 is identical.
4.1 Connection of the input
Connect the output of the musical instru-
will be
ment to the INPUT jack (3). Set the ATT.
sliding switch (5) fully to the left to position
"0 dB". Should there be any distortions on
the following mixer, set the switch to posi-
tion "-20 dB" or in case of very high sig-
nals to position "-40 dB".
Alternatively, the input jack can also be
connected to the speaker output of an
instrument amplifier to transmit the effect
on the sound by the amplifier.
with hum loops, the ground