Removing/Replacing The Ro Cartridge; Instructions For Installing And Operating The Bwt Bestaqua 14Roc App; Installing The App - BWT bestaqua 14ROC Instructions De Montage Et De Service

If the RO is out of service for a longer period of time (for example, during holidays), it is
necessary to rinse the device for five minutes. The flush water must be discarded to drain.
 NOTE!
Please observe the provisions in the operating manual of the external pre-filter used.
f

3.4 Removing/replacing the RO cartridge

Before removing the RO cartridge, shut off the feedwater supply. In addition, disconnect the
6
mains plug and ensure that the "Power-On LED" is no longer illuminated.
Please unscrew the old RO cartridge by tipping the RO device back slightly and then
unscrewing the old, depleted RO cartridge by turning it anti-clockwise.
7
Then screw in the new RO cartridge. Ensure that the opening in the tip of the RO cartridge is
fitted precisely concentrically to the feed plug.
8
The RO cartridge should normally be replaced every 12 months, but the correct interval may
vary depending on the raw water quality.
 NOTE!
After each RO cartridge change, run the device for 10 minutes to rinse the new cartridge.
f
Please note the internal pre-pressure setting of 2.0 bar.
3.5

Instructions for installing and operating the BWT bestaqua 14ROC app

3.5.1 Installing the app

If you have not yet installed the BWT bestaqua 14ROC app, please scan the QR code below. This
will take you to the website from which you can download the app.
23