Factory Reset - Pentair CHALLENGER VS2 Guide D'installation

15

Factory Reset

The drive can be reset to factory settings if necessary. A
Factory Reset will wipe out all of the saved user settings
that have been programmed, except for the time of day.
Be sure that it is necessary before performing a Factory
Reset, as the results are immediate.
To perform a Factory Reset:
1. Stop the pump if necessary by pressing the Start/
Stop button.
2. Record all of the custom schedule settings using
Table 3. You can find these setting by pressing
the "1", "2", "3", and "Quick Clean" buttons and
cycling through all the screens. Also write down
the Priming Speed.
3. Press and hold the "1", "2", "3", and "Quick Clean"
buttons for 3 seconds.
4. The screen will display "FACt rSt" if factory reset
is successful. See Figure 14.
5. Be sure to reprogram the schedule and priming
speed after the factory reset. The pump must be
turned back on with the Start/Stop button before it
will run again. The pump will run the programmed
schedule upon initial start-up.
Note: Factory Reset can not be performed from a
Keypad Lockout state.
FACt
Figure 14: Drive Factory Reset
Speed
(RPM)
SPEED 1
SPEED 2
SPEED 3
QUICK
CLEAN
Priming
Speed
Table 3: User Programmed Schedules
rSt
Duration Start Time
(Hours) (Time Clock)