SilverCrest SHBS 3.7 B1 Mode D'emploi page 101

BB*5$B%ERRN 6HLWH 0LWWZRFK  1RYHPEHU    
DANGER from batteries!
~ Ensure that the battery is not damaged as you remove
it. Fire hazard!
~ The removed battery must not be disassembled.
~ Never short-circuit the battery. The contacts on the re-
moved battery must not be connected by metallic ob-
jects. The battery may overheat and explode.
~ Only remove the battery to dispose of the device. The
device is destroyed by removing the battery. Never try
to operate a disassembled device.
1. Disconnect the device from the mains.
2. Switch on the device and let it run until the battery is
empty.
3. Figure A: remove the attachment|13,|3,|4,|12,|14
from the hair and beard trimmer|5 by pressing it with
the thumb towards the rear.
4. Figure D: use a Phillips screwdriver to release the
3 screws on the back and on the top end of the de-
vice.
5. Figure E: use a screwdriver to lever open the side
seam and unfold the two halves of the housing apart.
6. Figure F: release the 4 screws on the board and turn
it so that the battery faces you.
7. Figure G: release the connections between the battery
and the board with a pair of pliers/wire cutters. Remove
the exposed battery. Take the battery and the device sep-
arately to suitable disposal.
99
GB