SilverCrest SHBS 3.7 B1 Mode D'emploi page 88

BB*5$B%ERRN 6HLWH  0LWWZRFK  1RYHPEHU    
~ Only connect the power unit to a properly installed,
easily accessible wall socket, the voltage of which cor-
responds to the specifications on the rating plate. The
wall socket must continue to be easily accessible after
the device is plugged in.
~ Ensure that the cable cannot be damaged by sharp
edges or hot surfaces.
~ Ensure that the cable is not trapped or crushed.
~ When removing the power unit from the wall socket,
always pull the power unit and never the cable.
~ Pull the power unit out of the wall socket, ...
... after every use,
... after each charging process,
... if there is a fault,
... before connecting the device to the cable,
... before you clean the device and
... during thunderstorms.
~ To avoid any risk, do not make modifications to the de-
vice. Repairs must be carried out by a specialist work-
shop or the Service Centre.
DANGER from batteries
~ Protect the battery against mechanical damages. Fire
hazard!
~ Do not expose the device to direct sunshine or heat.
The ambient temperature should not be lower than
-10 °C and higher than +40 °C.
~ The charge contacts on the device must not be connect-
ed by metallic objects.
~ The battery may only be charged with the original ac-
cessory (power unit).
~ The battery only removed for disposal must not be
used again.
86
GB