SilverCrest SHBS 3.7 B1 Mode D'emploi page 98

BB*5$B%ERRN 6HLWH  0LWWZRFK  1RYHPEHU    
3. Apply a few drops of blade oil|16 to the cutting edge
of the attachment. Using a soft cloth, wipe off the sur-
plus oil, if necessary. Only use acid-free oil, such as
e.g. sewing machine oil.
Nose/ear hair trimmer attachment|
• Remove the nose/ear hair trimmer attachment|12.
Rinse it with water and let it dry completely before us-
ing it again.
Shaving attachment|
WARNING!
Do not detach the shaving foil from the shaving foil frame,
and do not clean it using the cleaning brush|17.
NOTE: from time to time, oil the cutting blade with a few
drops of acid-free oil (e.g. sewing machine oil). Attach the
shaving attachment to the hair and beard trimmer|5 and let
it run for a few seconds without using it. Using a soft cloth,
wipe off the surplus oil, if necessary.
1. Remove the shaving attachment|3.
2. Press the button on the side of the shaving attachment
and remove the shaving foil frame. While removing
the shaving foil frame, only hold it at the side and do
not press against the shaving foil.
3. Clean the cutting blade using the included cleaning
brush|17.
4. Clean the shaving foil in the shaving foil frame under
running water and allow it to dry completely before
putting it back on the shaving attachment|3.
96
GB
3
12