Warranty - Altrad Belle RPC 30/40 Manuel De L'opérateur

Assembly of the Control Pump
1. Carefully clean the housing with compressed air on the inside. Check for scratches on sliding bores for O Rings and there are
no sharp edges.
2. Press the Bushing in to Housing.
in the right position. When the Lip Seal is in the Groove this represents forward motion.
CAUTION
In reverse motion the Control Handles run parallel with the Housing in the direction of the operator.
to Reverse. (See CAUTION
7. Lubricate the Pinion and O Rings with hydraulic oil and carefully insert in to the Housing. Make sure the Rack is in the right
position and this is easiest when in reverse motion.
8. Fit the Shim and Retaining Ring. It may be necessary to push the Pinion from the opposite side to get them assembled.
10. Assemble the Hydraulic Connector and Dowty Washer using LOCTITE 243.
operation or user maintenance instructions.
The following components are not covered by warranty.
• Drivebelt/s
•
• Engine spark plug
Warranty Claims
For warranty claims:
Write to:
SK17 0EU
England.
Warranty Registration:
http://www.bellegroup.com/index.php?p=warranty_registration
the registration page.
Service & Maintenance
LOCTITE 243.
DO NOT TIGHTEN.

Warranty

31
LOCTITE seal 518 is recommended.
-