Trouble Shooting Guide - Altrad Belle RPC 30/40 Manuel De L'opérateur

Problem
Engine will not start.
Engine still will not start.
Unit will not move.
Forward speed too slow.
Reverse speed too slow.
Loss of Hydraulic Oil.
Machine operates
erratically.
important that the simple regular maintenance listed in this section is carried out. It is recommended that an approved Altrad Belle
void your warranty.
switch is in the stop position.
Running In Period
Drive Belt

Trouble Shooting Guide

Cause
No fuel.
Spark plug fouled.
Engine cold.
Engine speed too slow.
Drive belt tension loose.
Worn or Damaged Clutch.
Drive failure.
Gearbox failure.
Too much oil in hydraulic head.
Not enough oil in hydraulic head.
Air in control system.
Connectors leaking.
Defective hydraulic hose.
Piston seal in gearbox defective.
Shock mounts damaged.
Service & Maintenance
Remedy
Open fuel tap.
Fill fuel tank.
Switch engine on.
Clean and reset plug gap.
Close choke.
then repeat start procedure.
Contact Agent or Altrad Belle.
Set engine speed control to fast.
Repair or Replace as necessary.
Contact Agent or Altrad Belle.
Contact Agent or Altrad Belle.
Reduce oil level.
Contact Agent or Altrad Belle.
Fill and bleed system.
Bleed control system.
Contact Agent or Altrad Belle.
Reseal connectors.
Replace hose.
Contact Agent or Altrad Belle.
Replace all four mounts.
29
-