R.G.V. Juice Art Digital Manuel D'utilisation page 46

EN
13. Slide the food pusher (9) down the food chute.
The pusher can only fit one way.
Before using the device make sure
that the basket (6) is not damaged.
In that case proceed to its replace-
ment using original spare parts.
14. Prepare the food to be processed by cutting it into size-wise pieces so that they could be
inserted in the tray hole (9). Other fruit or vegetables have to be inserted in the little duct
and pushed with the pusher in order to obtain the juice.
Discard the hard parts (stones, seeds, etc.).
15. Electrically connect the device, verifying that the
network data fit with those on the data plate of the
device itself.
16. Turn on the device and select the desired program (see
paragraph "J1").
Do not touch the control panel with wet hands.
17. To close the anti-drip cap (4c) of the juice pouring spout (4a) and to open it at the end of
the pressing or when the juice level in the separator (4) is at maximum level is advised.
This allows a reduced contact of the juice with air, this means less oxidation of the juice
itself and, in case of pressing of different food simultaneously, a more homogeneous
mixing of the final juice.
18. Insert in the tray duct (9)
the food cut and pre-
pared previously (see
"Tips" paragraph).
19. Open the anti-dry cap (4d)
of the pulp pouring spout
(4b).
20. Press "Start" to start the
device.
46
10
9
4c
10
220-240V~ 50/60Hz
9
8
4d