R.G.V. Juice Art Digital Manuel D'utilisation page 42

EN
Use
K
K1 - FIRST USE
1. Before placing the separator (4) on the motor base (1) make sure that the rubber bearing
(X) is correctly installed.
If the rubber bearing (X) is not placed correctly and it's not in good
condition some liquid losses could occur during the food pressing.
Carry out this verification before any use of the device.
2. Install the anti-drip cap (4c) on the juice pouring spout (4a).
3. Install the anti-drip cap (4d) on the pulp pouring spout (4b).
4c
4a
4. Clean the device as described in "Cleaning before use".
42
4
X
4b
4
4d