Festool OSC 18 Notice D'utilisation D'origine page 15

11-1
9
USB 78/42/BI/OSC
USB 78/32/BI/OSC
Readjusting the saw blade guide
First check to ensure that the application tool
has been inserted in the correct order (see fig­
ure [10]). If the saw blade is still not positioned
on the saw blade guide, take the following
steps:
► Set the cutting depth [11-1] to the maxi­
mum depth. Tighten the cutting depth ad­
justment [11-1].
► Loosen the screw [12-1] on the saw blade
guide [12-2].
► Move the saw blade guide to the saw blade.
► Tighten the screw [12-1] on the saw blade
guide.
12-1
12-2
12.5 SYSTAINER
Systainer
11a Many Festool products are shipped in a unique
system container, called "Systainer". This pro­
vides protection and storage for the tool and ac­
cessories. The Systainers are stackable and
can be interlocked together. They also can be
interlocked atop Festool CT dust extractors.
To open the Systainer
To lock the Systainer
11-2
11b
To connect two Systainers
Place one Systainer on the top of the other
(Fig. [SYS-a]).
The Systainers are connected and locked.
A new generation Systainer is connectable
on top of a previous generation Systainer
by the four latches of the previous
Systainer.
Turn the T-loc [SYS-b-1] to this posi­
tion.
Turn the T-loc [SYS-b-1] to this posi­
tion.
Turn the T-loc [SYS-b-1] to one of
this positions (Fig. [SYS-b]).
English
12
15