Inspection And Maintenance Plan - Güde GADH 200 Mode D'emploi D'origine

Failure removal
Before rectifying a fault on the machine, switch
off the machine and pull out the mains plug.
Failures
Machine does not work or
stops suddenly
Machine stops during
planing
Workpiece jams during
thicknessing
Unsatisfactory surface
finish
Machined surface too
rough
Machined surface cracked • Workpiece was machined against the
Workpiece speed too low
during thicknessing
Enable and check all safety equipment after all
troubleshooting work.

Inspection and maintenance plan

Regular servicing period
Check that the planing blade is in perfect
condition
Check the function of the safety equipment
Clean dust and chips off the machine
Check the drive belt to ensure it has the
correct tension and is in good condition or
not worn
Oil or grease all moving connecting parts
Causes
• Power cut
• Motor or switch defective
• Check microswitch
• Planing blade blunt/worn
• Overload switch has tripped
• Check microswitch
• Cutting depth too great
• Planing blade blunt/worn
• Planing blade filled with chips
• Uneven feed
• Workpiece contains too much moisture • Dry workpiece
grain
• Too much material planed at one pass
• Workpiece was machined against the
grain
• Too much material planed at one pass
Inspection
Change
Inspection
Change
Clean
Inspection
Change
Removal
• Check fuse, check overload switch on
machine.
• Have the motor or switch checked by
an electrician.
• Fit the chip extractor hood so that the
microswitch is pressed.
• Replace or sharpen blade
• Switch on the motor again once it has
cooled
• Fit the chip extractor hood or bench
lock so that the microswitch is pressed.
6
• Reduce cutting depth and machine the
workpiece in several passes
• Replace or sharpen blade
• Remove chips
• Feed the workpiece with constant
pressure and at reduced speed
• Machine the workpiece from the oppo-
site direction
• Machine the workpiece in several
passes
• Clean bench top and apply a thin
coating of lubricant wax
• Repair transport rollers
• Set the lever for the thicknessing
setting to the top position
Before any If necessary
start-up
ENGLISH
6
Once a After 6
week months
45