IMPORTANT The way the Camoplast Hi-Performance Tracks UTV T4S track system is used, is directly linked with the longevity of the system components. Sportive driving, rapid direction changes and repeated fast turns (more specifically on power steering vehicles) are not advised. This way of driving increases the risk of derailing and can cause premature wear and or major breakdowns on the track system which will not be covered under normal warranty.
Page 3
Page 3 Installation Guidelines / Directives d’installation FRONT ANCHOR BRACKET PARTS LIST / LISTE DE PIÈCES - ANCRAGE AVANT Figure 1 ITEM DESCRIPTION 1004-04-0120 FRONT BRACKET KIT / ENSEMBLE ANCRAGE AVANT 1004-04-1005 FRONT LEFT ANCHOR BRACKET / ANCRAGE AVANT GAUCHE 1004-04-1015 FRONT RIGHT ANCHOR BRACKET / ANCRAGE AVANT DROIT 1006-04-0037 FRONT BRACKET COVER / COUVERT ANCRAGE AVANT 1033-10-0055 HEX BOLT / BOULON HEX - HCS, M10-1.5X55, 8.8, ZP, DIN931...
Page 7
Page 7 Installation Guidelines / Directives d’installation PREPARATION / PRÉPARATION WARNING AVERTISSEMENT Never place parts of your body under the vehicle Ne jamais exposer des parties de votre corps unless it is securely placed on appropriate stands. sous le véhicule à moins que celui-ci ne repose Severe injuries could occur if the vehicle collapses sur des supports appropriés.
Page 9
Page 9 Installation Guidelines / Directives d’installation 5. Remove assembly bolt (A) linking the lower 5. Dévisser et retirer le boulon (A) qui relie le bras suspension arm to the wheel hub. See Figure 9. inférieur de suspension au moyeu de roue. Voir la Figure 9.
Page 11
Page 11 Installation Guidelines / Directives d’installation 10. Secure undercarriage to rear hub using the 10. Fixer le système de traction au moyeu de roue wheel nuts (18) provided. Refer to Figure 13. arrière, utiliser les écrous (18) de roue fournis. Voir la Figure 13.
Page 13
Page 13 Installation Guidelines / Directives d’installation FRONT TRACK SYSTEMS / SYSTÈMES DE TRACTION AVANT 1. Using a lifting device, raise the front of the 1. Au moyen d’un dispositif de levage, soulever vehicle and install appropriate stands. Ensure l’avant du véhicule et installer des cales de that the vehicle is immobilized and safe to work sûreté.
Page 15
Page 15 Installation Guidelines / Directives d’installation 7. Using the wheel nuts (18) provided, secure 7. Au moyen des écrous de roue (18) fournis, undercarriages to front wheel hubs. The boulonner chaque système de traction au procedure and precautions are the same as for moyeu de roue avant.
Page 17
Page 17 Installation Guidelines / Directives d’installation 5. Install bushing (14) in mounting bracket. Insert 5. Installer l’espaceur (14) au logement de new M12x65mm bolt (13) through lift plates, l’amortisseur. Insérer nouveau boulon mounting bracket and bushing. Install provided M12x65mm (13) à travers les plaques de nut (15) but do not tighten it completely.