Package Contents; Description Of The Product; Fitting The Battery - Num'axes iki voice Guide D'utilisation

Package contents

- a collar equipped with a short bark sensor
- a nylon strap
- a slide buckle for the strap
- a 3 Volt CR 2450 lithium battery

Description of the product

Nylon strap

Fitting the battery

- Remove the 2 screws from the battery cover with the supplied screwdriver.
- Remove the battery cover.
- Insert the 3 Volt CR 2450 lithium battery as indicated under the battery holder (See diagram 2).
- A sound beep is emitted indicating that the battery has been properly inserted.
- If you do not hear any sound beep after inserting the battery, immediately remove it from the battery
holder by using the supplied magnet (magnetic key). Check the polarity before inserting the battery
once again. If you still do not hear any sound beep, check the operation by switching the collar On
and Off.
- Replace the battery cover taking care to first insert the little pin at the bottom of the battery cover
(See diagram 3).
- Retighten moderately the 2 screws.
Diagram 2
« + » terminal of the
battery downward
Diagram 1
- a magnetic key (magnet)
- a long bark sensor
- a screwdriver
- this user's manual
Sensor
(short or long)
Gb - 14
Orange mark:
Area where the magnet is located to
switch On/Off or change mode of
operation
Diagram 3
Replace the battery cover taking care
to first insert the little pin at the
bottom of the battery cover