Insertion Of The Réglette - CEMB SM628BPS Manuel D'utilisation

6.3.7 Insertion Of The Réglette
There is a special way to insert the réglette. The part with the lever housing is to be
held towards the exterior of the wheel. During rotational movement in order to insert the
réglette, the tang must pass under the cylindrical roller.
- Lift the roller by acting on the pneumatic lever switch (G) and move it backwards.
- Insert the lever into the réglette housing, fi g.33.
- Lift the bead by pressing on the centre of the wheel, fi g 33.
Make sure that the lever is well inserted under the bead before lifting the bead.
- After bead breaking, immediately remove the réglette from the tyre fi g. 34
Be careful not to drop the réglette inside the tyre. You might leave it inside the
tyre during the next mounting.
Be very careful to avoid contact between the bead of the tyre and the pressure
transducer, and between the pressure transducer and the demounting/mounting
tools. Contacts with unusual stress may damage the sensors or create sealing
defects between the valve and the rim.
User's manual
WARNING
34
WARNING
WARNING
EN
35
27