Installing The Maxi-Cosi Cabriofix In Your Car; Installing The Maxi-Cosi Cabriofix With A Safety Belt - Maxi-Cosi CabrioFix Mode D'emploi & Garantie

4. INSTALLING THE MAXI-COSI CABRIOFIX IN YOUR CAR

4.1 Installing the Maxi-Cosi CabrioFix with a safety belt

The Maxi-Cosi CabrioFix can be fitted safely on almost all forward-facing seats in the car using the existing
seat belts. However, the belts are fitted so far forward on some seats that proper installation is not possible.
If this is the case, try another seat.
In some cases, the buckle of the safety belt may be too long and therefore sits too high against the base of
the Maxi-Cosi CabrioFix, making it difficult to install the Maxi-Cosi CabrioFix securely. If this is the case,
choose another position in the car. Contact your supplier with any questions.
*if there is a seat belt present in the middle position of the back seat.
Important! Do not mix up hip (9,1) and shoulder part (9,2)!
9
• Place the Maxi-Cosi CabrioFix in a rearward-facing position on the seat, therefore with the back forward
10
facing. The carrying handle must be locked in an upright position (10).
• Thread the lap section of the seat belt across the front (foot end) between the shell and two blue belt
11
hooks (11).
Instructions for use
• Installation with 3-point safety belt
• Installation with 2-point safety belt
• On passenger seat
• On left/right side of back seat
• In middle position of back seat
• Belt routing marking
• Frontal airbag
• Side airbag
GB
Yes
No
Yes
Yes
Yes*
Blue
No
Yes
13