Placing Your Child In The Maxi-Cosi Tobi; Using The Harness System - Maxi-Cosi Tobi Mode D'emploi & Garantie

EXI0203_GBA_Tobi_I_BW:--
• When the seat belt has been installed properly, the various "views" will look as follows:
on the side of the roll-up
Opposite side belt buckle.
GB
Checklist...
To ensure the optimum safety of the child, after installing the seat check once more that...
• the seat belt is tight and that it is not twisted,
• the hip part of the seat belt passes over the red belt marks and belt tensioner(s),
• the (diagonal) shoulder part of the seat belt is attached properly and passes through the two belt slots,
along the red marks on the rear of the Maxi-Cosi Tobi,
• both belt clamps are closed,
• the belt tensioner(s) is in the tensioned, vertical position,
• the entire Maxi-Cosi Tobi is installed securely and firmly in the car.
B. Removing the Maxi-Cosi Tobi
• Open the belt buckle of the seat belt (11).
11
12 • Next, open both belt clamps (12).
13 • Release the belt tensioner by pressing the button (13). The belt tensioner will now move down, into the
horizontal position.
14 • Remove the seat belt from the belt slots (14).
• Take the Maxi-Cosi Tobi out of the car.

3. PLACING YOUR CHILD IN THE MAXI-COSI TOBI

3.1 Using the harness system

A. Adjusting the height of the harness
Before placing the child in the Maxi-Cosi Tobi and locking the harness belt, first determine the correct
height of the shoulder belts and headrest.
• Open the belt buckle (15) by pressing the red button of the belt buckle.
15
• The shoulder belts are now automatically released and can be made longer without pressing any other buttons.
16
• Loosen the shoulder belts by pulling them forwards as far as possible (16).
• NOTE! Do not pull on the belt pads when doing so.
17 • Place the child with his/her back straight in the Maxi-Cosi Tobi and check the belt height (17).
18 • NOTE! The height of the shoulder belts is correct when the belt disappears into the shell slightly above
your child's shoulders (18).
• Adjust the height of the shoulder belts in combination with and by means of the headrest.
19 • To move the shoulder belts and headrest to the required height, move the headrest by the handle on the
top at the same time forwards and up or down (19). The shoulder belts including headrest can be set to
6 different heights.
10
02-10-2008 15:21
Side view,
mechanism.
English
Pagina 10
Rear view
on the side where the belt buckle
Side view,
is located.