SIMPLE LOGGER II
MODEL
Electrical
Inputs
Input connection
Input levels(3 ranges / input)
Maximum input level
Uncertainties (50 / 60 Hz)
Resolutions
Input impedance
Sample rate
Storage rate
Storage modes
Recording length
Memory
Communication
Power source **
Battery life
Mechanical
Dimensions
Weight (with batteries)
Case
Vibration
Shock
Drop
Environmental
Operating temperature
Storage temperature
Relative humidity
Altitude
Safety
Conformity
Level of protection
*See the end of chapter
removable 4-position screw-type terminal block
Range 1:
Range 2:
Range 3:
± 1/2 x nominal range
Range 1:
Range 2:
Range 3:
Range 1:
Range 2:
Range 3:
100 mV & 1 V: 80 kΩ; 10 V : 800 kΩ
100 mV & 1 V: 80 kΩ; 10 V : 800 kΩ
8 samples maximum per recording interval
Programmable from 125 ms to 1 day
Start/Stop, FIFO or Extended Recording Mode* (XRM™)
Programmable using DataView
240,000 measurements (512 kB). The recorded data is stored in
non-volatile memory retained even if the battery is low or removed.
USB 2.0 optically isolated
2 x 1.5 V AA (LR6) cell Alkaline batteries
100 hours to >45 days (dependent on storage rate/recording length)
136x70x32 mm (5.38x2.75x1.28")
IEC 68-2-6 (1,5 mm, 10 to 55 Hz)
IEC 68-2-27 (30 G)
IEC 68-2-32 (1 m)
-10°C to + 50°C (14°F to 122°F)
- 20°C to + 60°C (- 4°F to + 140°F)
up to 85% at 35°C (95°F) without condensation
EN 61010-1; 50 V CAT III; Pollution level 2
L432
Two
- 100 mV to + 100 mV
DC
- 1 V to + 1 V
DC
- 10 V to + 10 V
DC
± (0,5% of reading + 1 mV)
± (0,5% of reading + 1 mV)
± (0,5% of reading + 10 mV)
0,1 mV
1 mV
10 mV
®
from 15 minutes to 8 weeks
180 g (6.4 oz)
UL94-V0
2000 m
IP 40
English
Page 46