Characteristics - Chauvin Arnoux SIMPLE LOGGER II Notice De Fonctionnement

SIMPLE LOGGER II
6. "Flash Upgrade" switches (not shown)
These two switches, placed near the "RESET" button, are used to take control of the device if an upgrade of
the internal operating program fails.
WARNING: if the "RESET" button is actuated while recording is in progress, recording will be
interrupted and the data in memory may be lost.
Reference conditions: 23°C ± 3°C, 30-50% RH, DC or 50/60Hz, no external AC magnetic field, DC magnetic
field ≤ 40 A / m, conductor centred, supply voltage: 3 V ± 10%.
MODEL
Electrical
Inputs
Input connection
Input level
Uncertainties(50 / 60 Hz)
Resolution
Maximum input level
Input impedance
Sample rate
Storage rate
Storage modes
Recording length
Memory
Communication
Power source **
Battery life
Mechanical
Dimensions
Weight (with batteries)
Case
Vibration
Shock
Drop
Environmental
Operating temperature
Storage temperature
Relative humidity
Altitude
Safety
Conformity
Level of protection
*See the end of chapter

3. CHARACTERISTICS

L101
One
10 to 50 mV: ± (0.5% of reading + 1 mV)
Start / Stop, FIFO or Extended Recording Mode* (XRM™)
Programmable using DataView
240,000 measurements (512 kB). The recorded data is stored in non-volatile
memory retained even if the battery is low or removed.
2 x 1.5 V AA (LR6) cell Alkaline batteries
100 hours to >45 days (dependent on storage rate/recording length)
up to 85% at 35°C (95°F) without condensation
EN 61010-1; 50 V CAT III; Pollution level 2
BNC
0 to 1 V
AC
0 to 10 mV: unspecified
50 to 1,000 mV: ± ( 0,5 mV + 0,5 mV)
0,1 mV
AC
5 Vrms or ± 7.07 Vpeak
800 kΩ
64 samples/cycle
Programmable from 125 ms to 1 day
®
from 15 minutes to 8 weeks
USB 2.0 optically isolated
136x70x32 mm (5.38x2.75x1.28")
180 g (6.4 oz)
UL94-V0
IEC 68-2-6 (1.5 mm, 10 to 55 Hz)
IEC 68-2-27 (30 G)
IEC 68-2-32 (1 m)
- 10°C to + 50°C (14°F to 122°F)
- 20°C to + 60°C (- 4°F to + 140°F)
2,000 m
IP 40
English
L102
Two
Page 43