Maintenance; Replacement Of The Batteries - Chauvin Arnoux SIMPLE LOGGER II Notice De Fonctionnement

Masquer les pouces Voir aussi pour SIMPLE LOGGER II:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 1
SIMPLE LOGGER II
All of the instruments undergo mechanical and electronic checks before shipping. Every precaution is taken
to ensure that you receive an undamaged instrument. If there is any damage, inform the carrier immediately.
The manufacturer cannot be held liable for any incident, accident, or malfunction following a repair done
other than by its customer service department or an approved repairer.

5.1 REPLACEMENT OF THE BATTERIES

Disconnect all inputs or remove the clamp from any conductor before opening.
Switch the device off
Remove the screw holding the cover, press on the cover and slide it off.
Replace the two 1.5 V AA (LR6) alkaline batteries. Do not remove both batteries at once; replace only the
first one completely, then the other. (The maintenance capacitor can maintain a supply for approximately 10
seconds while the batteries are being replaced.)
Replace the battery compartment cover and the screw
Keep the "PRESS" button pressed for 2 seconds to restart the device.
NOTE: If the device is left too long without batteries, it will be necessary, after replacing the
batteries, to reset the date and time from the control panel of the Simple Logger
Leave the batteries in the device only for short periods of time. If the device is to be left unused for an
extended period, we recommend removing the batteries.
When replacing the batteries, always replace them both. Never leave an old battery in place next to a new
one.
NOTE: When batteries are inserted into the instrument, the memory will be marked as full.
Therefore, before starting a recording, the memory must be erased:
1. Click Instrument in the menu bar, and select Erase Memory.
2. Select Yes when asked to verify erasing the memory

5. MAINTENANCE

WARNING: Risk of electric shock. Disconnect all inputs or remove the clamp from
any conductor before opening the battery compartment cover. To eliminate the risk
of loss of recorded data, switch the device off before changing the batteries.
English
®
II.
Page 65

Publicité

Table des Matières
loading

Table des Matières