Assembly And Installation; Motion Detector - Pentatech CA 300 Mode D'emploi

Assembly and installation

larger cable opening in the rear of the control unit.
Connect this cable using the 3-pin plug to the main circuit
board of the control unit (see Fig.C P a).
Guide the cable of the external siren w through the
smaller cable opening in the rear of the control unit.
Connect this cable using the 2-pin plug to the main circuit
board of the control unit (see Fig.C O a).
Insert the four batteries 1.5 V type LR6 (mignon / AA,
alkaline) observing the correct polarity (helical spring to
the negative pole of the battery) into the battery holder } .
The device emits a 2-pip sound.
Place the battery holder } back into the battery com-
partment of the control unit and reattach the rear T of
the battery compartment with the fastening screws Y .
Push the top mounting point U over the top screw
head at the same time as you push the bottom mounting
point { over the bottom screw head.
Readjust the screw heads if this is necessary to obtain
a secure seating for the device.
Ensure that the sabotage contact I (on the rear of
housing) is pressed and lies fl ush against the installation
site surface.
External siren
Tip! If you need to drill a cable feed hole for the external
siren then you should ensure that the hole is hidden
behind the siren housing. Ensure the hole is big enough
for the socket connector of the cable w . Guide the cable
of the siren from the outside through the hole and connect
the plug to the control unit as described above.
Mark two holes 60 mm apart at the selected position.
Drill the two holes for the two dowels (27 x 6 mm) and
insert the dowels into the holes.
Screw the two mounting screws (22 x 4 mm) into the
dowels until the screw heads project approx. 5 mm.
Unscrew the 4 fastening screws of the external siren and
remove the rear of the housing.
Insert the four batteries 1.5 V type LR6 (mignon / AA,
alkaline) observing the correct polarity (helical spring to the
28 GB
negative pole of the batteries) into the battery holder y .
Place the battery holder y back into the battery com-
partment of the external siren and reattach the rear of
the battery compartment with the fastening screws.
Push the top mounting point e over the top screw
head at the same time as you push the bottom mounting
point e a over the bottom screw head.
Readjust the screw heads if this is necessary to obtain
a secure seating for the device.
Ensure that the sabotage contact r (on the rear of the
housing) is pressed and lies fl ush against the installation
site surface.

Motion detector

Double-sided adhesive strips
o Attach the motion detector using the two double-sided
adhesive strips.
or
the mounting screws and dowels
Attention! Make sure that the motion detector is not dam-
aged in any way during the drilling of the mounting holes!
Unlock the front of the housing of the motion detector
using a small fl at-headed screwdriver (see Fig. G) and
separate it from the rear of the housing o .
Drill out the two preformed breakthrough points p to
form the mounting holes using a hand drill / electronic
screwdriver to a diameter of 2 mm. The holes may be
side by side or one under the other.
Mark the two mounting holes p at the selected instal-
lation position.
Drill the two holes for the two dowels (22 x 5 mm) and
insert the dowels into the holes.
Mount the rear of the housing o by screwing the two
mounting screws (22 x 3 mm) into the dowels.
Engage the front of the housing with the top edge of the
rear of the housing o . Then pivot the front fully down
until the front engages completely with the rear.