Pentatech CA 300 Mode D'emploi page 24

Introduction
Introduction
Please read the operating instructions thoroughly and care-
fully before initial operation of the device and open out the
pages showing the illustrations and fi gures. The instruction
manual is part of this product and contains important infor-
mation relating to initial operation and handling. Please always
observe all safety instructions. Before initial operation, please
check that all parts are fi tted correctly. If you have any
questions or are unsure about handling of the device, please
consult a specialist. Please keep these instructions in a safe
place. If you give the device to anyone else, please also pass
on all documents supplied with it.
Proper use
The CA 300 compact alarm system is specially designed for
the protection of smaller properties such as apartments,
holiday homes, caravans or garages. The alarm is battery-
operated (8 x 1.5 V type LR6 batteries, mignon / AA, alkaline)
(not included), which also makes it suitable for properties
without mains electricity. The control unit can be programmed
with a user code (one to ten digits).This unit and the movement
detector are suitable for use in dry indoor spaces only. The
loud external siren is suitable for indoor or outdoor use. The
device is for private use only. Any other use or modifi cation
of the device constitutes improper use and poses a serious
risk of accident. The manufacturer is not liable for damage
caused by improper use or incorrect operation of the device.
Included items
1 Control unit
4 Mounting screws 22 x 4 mm
4 Dowels 27 x 6 mm
1 External siren
2 Mounting screws 22 x 3 mm
2 Dowels 22 x 5 mm
1 Motion detector
2 Two-sided adhesive strips 15 x 45 x 2 mm (H x L x W)
10 Cable clips (including nails)
1 Operating instructions
24 GB
Features and equipment
Front control unit (see Fig. A)
Q Speaker (internal siren)
W LED
(green)
E LED
(red)
R Keypad
Rear control unit (see Fig. B)
T Rear of housing
Y Fastening screws (4 x)
U Top mounting point
I Sabotage contact
O Cable feed hole (external siren / control unit)
P Cable feed hole (motion detector / control unit)
{ Bottom mounting point
w Cable (including socket connector) (external siren /
control unit)
i Cable (motion detector / control unit)
Rear (open) / battery compartment control unit (see Fig. C)
O a Plug connector external siren
P a Plug connector motion detector
} Battery holder
w Cable (including socket connector) (external siren /
control unit)
i Cable (motion detector / control unit)
Front external siren (see Fig. D)
q Speaker (external siren)
w Cable (including socket connector) (external siren /
control unit)
Rear external siren (see Fig. E)
e Top mounting point
e a Bottom mounting point
r Sabotage contact
t Mounting screws (4 x)
Battery compartment external siren (see Fig. F)
y Battery holder