Table des Matières
Publicité
5. Trouble-Shooting
Problem
Pump is running,
but doesn't deliver.
Pump doesn't start or
suddenly stops during
operation.
Pump runs, but output
suddenly decreases.
If any other faults occur, please contact GARDENA Service.
6. After Operation
Putting into Storage:
Disposal:
(in accordance with
directive 20002/96/EC)
Probable cause
Air cannot escape, since
pressure line is closed.
Air locks in suction base.
Suction base
clogged.
When starting the pump,
the water level faIls be-
low the min. water level.
Thermal overload switch
has switched the pump
off due to overheating.
No power.
Suction base clogged.
➔ To protect the pump from frost damage, store the pump in a
dry place.
Unit may not be disposed of with normal household waste but
must be disposed of in accordance with environmental
regulations.
Remedy
Open pressure line (e.g. kinked
pressure pipe).
Wait for max. 60 seconds
until the pump deaerates auto-
matically over the vent valve.
Clean suction base (see
point 4).
Submerge pump deeper
(see min. submersion depth,
point 7).
Disconnect plug and clean
turbine (see point 4). Observe
max. liquid temperature (35 °C).
Check fuses and electric
connections.
Clean suction base (see
point 4).
11
Publicité
Table des Matières
