How To Charge The Batteries - Clarke Fusion 27 Manuel De L'utilisateur

Masquer les pouces

Table Des Matières

Table des Matières

Page

-24-

HOW TO PREPARE THE MACHINE

FOR OPERATION

CAUTION:

Irreversible damage will occur to

the batteries if the electrolyte level

does not cover the plates. Keep the

electrolyte at the correct level.

3. Reinstall the caps.

4. After charging, top off the batteries. NOTE: USE

DISTILLED WATER ONLY. THIS SHOULD BE

DONE AFTER CHARGING. The maximum level is

within 1/4 inch of the bottom of the tube in each cell.

See figure 5 B. For instructions on how to charge the

batteries, see "How To Charge The Batteries" below.

CAUTION:

Machine damage and discharge

across the tops of the batteries can

occur if the batteries are filled

above the bottom of the tube in

each cell. Do not fill the batteries

up to the bottom of the tube in each

cell.

machine or the tops of the batter-

ies. Never add acid to a battery

after installation.

CAUTION:

Tap water may contain contami-

nants that will damage batteries.

Batteries must be re-filled with dis-

tilled water only.

5. Keep the tops of the batteries clean and dry.

Keep the terminals and connectors clean. To clean the

top of the batteries, use a damp cloth with a weak

solution of ammonia or bicarbonate of soda solution.

To clean the terminals and connectors, use a terminal

and connector cleaning tool. Do not allow ammonia or

bicarbonate of soda to get into batteries.

6. Keep the batteries charged.