How To Charge The Batteries; Recharging The Batteries; Level Indicators For The Charge On The Batteries - Clarke FOCUS 28 Disc Manuel D'utilisation

ENGLISH
EN
How To Prepare the Machine For Operation

How to Charge the Batteries

WARNING: Charging the batteries in an area
without adequate ventilation could
result in an explosion. To prevent an
explosion, charge the batteries only in
an area with good ventilation.
WARNING: Lead acid batteries generate gases
which could explode. Keep sparks
and flames away from batteries. NO
SMOKING!
To charge the batteries, follow this procedure:
1. Make sure the key switch is in the "OFF" position.
2. Raise the seat base support.
3. Connect the battery charger AC cord to a 15 amp (min)
120V properly grounded wall receptacle.
4. Observe indicator light to ensure the charging process
has started (see figure 5, A - Red, B - Yellow, and C -
Green ). For color indications see figure 6.

Recharging the Batteries

The Focus Rider Scrubber comes with an on board charger.
1. Plug into any wall socket and charging is automatic.
2. Observe indicator light to ensure the charging process
has started (see figure 5, A - Red, B - Yellow, and C -
Green ). For color indications see figure 6.
NOTE: Make sure you plug into a circuit that is not loaded by
other equipment. Wall breakers may be tripped and no
charge will occur.
WARNING: Never charge a GEL battery with an
unsuitable battery charger. Carefully
follow the instructions given by the
manufacturer of the batteries and
battery charger.
NOTE: To prevent permanent damage to the batteries, avoid
their complete discharge. Never leave the batteries
completely discharged, even if the machine is not being
used. When recharging the batteries, keep the base
support of the seat lifted. After every 20 recharging
operations, check the level of the electrolyte and if necessary
top off with distilled water.
Level Indicators for the Charge of the Batteries
The battery meter ( see figure 7) on the control panel has a
digital read out with 10 fixed positions (A) and also a
blinking indicator (B). The bars that appear on the display
show the approximate charge level with icon (blinking)
discharged battery.
NOTE: A few seconds after the voltage reads 32V it will start
blinking. The brush motors will then automatically switch
off.
Page -12-
(Shown with Optional Chemical Mixing System)
Figure 5
A B
Figure 6
A
B
Figure 7
Clarke ®
Operator's Manual (EN) - Focus Rider
C