Switching Between Wind Speed/Gust Speed; Display Of The Wind Direction; Display Of The Rain Volume; Display/Reset Maximum/Minimum Values - Conrad 51 54 74 Notice D'emploi

h) Switching between Wind Speed/Gust Speed
• Push the button „SELECT/Zz" (1) several times briefly until the right edge of the display shows an arrow „ " next to
the wind speed display.
• Briefly push the button „MODE/SET" (2) to switch at any time between:
„GUST" Gust speed: Display of the maximum wind speed of the last 10 hours
„AVERAGE" Average wind speed: Average value of the wind speeds of the last 2 minutes
i) Display of the Wind Direction
• To the left of the wind speed display, a compass rose shows the wind direction.
• The arrow indicates the average wind direction of the last 2 minutes.
j) Display of the Rain Volume
• Push the button „SELECT/Zz" (1) several times briefly until the right edge of the display shows an arrow „ " next to
rain volume display.
• Briefly push the button „MODE/SET" (2) to switch at any time between:
„DAILY" rain volume of the last 24 hours
„WEEKLY" Rain volume of the last 7 days
„MONTHLY" Rain volume of the last month
„TOTAL" Total rain volume since recording started
At the same time, the lower left of the display shows a graphic display of the rain volume curve of the last 6 hours.
If the total rain volume („TOTAL") is displayed, it can be reset to „0.00" by pushing the button „MEM/-" for 3
seconds.
k) Display/Reset Maximum/Minimum Values
• First select the desired sensor; see chapter 11. d).
• Briefly press the button „MEM/-" (4) repeatedly to switch between the following values:
- Maximum values („MAX" in the display)
- Minimum values („MIN" in the display)
- Current measured values
• To reset the maximum and minimum values, first have the maximum or minimum values displayed as described
above with the button „MEM/-" (4) (the display shows „MAX" or „MIN").
Now keep the button „MEM/-" (4) pushed for about 3 seconds. All saved values will be reset.
48