What To Do If Trouble Occurs - Asko HIHM934M Instructions D'utilisation

6 What to do if trouble occurs?

Interference with and repairs to the appliance by
unqualifi ed persons are dangerous as they can result
in an electric shock or a short circuit. Do not interfere
with or try to repair the appliance; this could cause injury
to persons and damage to the appliance. Always have
such work done by an expert, e.g. a Customer Service
technician.
Please note
If your appliance is faulty, please check whether you
can rectify the problem yourself by consulting these
instructions for use.
You may be able to rectify some problems yourself.
They are described below.
The fuses blow regularly?
Contact a technical customer service or a service
technician!
You can't switch your induction hob on?
• Has the wiring system (fuse box) in the house blown
a fuse?
• Has the hob been connected to the mains?
• Is the childproof lock activated, i.e. does the display
show an "L"?
• Are the sensor keys partly covered by a damp cloth,
fl uid or a metallic object? Please rectify.
• Are you using unsuitable cookware? See the section
on Cookware for induction hobs.
The symbol will blink and a time-limited
continuous signal will sound.
Food which has boiled over, cookware or other items are
causing the touch control sensor keys to be consistently
operated.
Remedy: clean the surface or remove the item. To delete
the symbol press the same key or switch the induction
hob off and on.
Error code E2 is indicated?
The electronic unit is too hot. Check the installation
of the induction hob. Make sure that there is suffi cient
ventilation.
See the section on "Protection against overheating". See
the section on "Ventilation".
20
What to do if trouble occurs?
Error code E8 is indicated?
Fault on the left or right fan. The suction opening is
blocked or covered or the fan is defect.
Check the installation of the hob. Make sure that there is
suffi cient ventilation.
See the section on "Protection against overheating". See
the section on "Ventilation".
Error code U400 is indicated?
The hob has been incorrectly connected. The controls
will switch off after 1s and a continuous signal will sound.
Connect the appliance to the appropriate power supply.
An error code (ERxx or Ex) is indicated?
The appliance has developed a technical defect. Please
call Customer Service.
The pot sign
A cooking zone has been switched on and the hob is
expecting a suitable pot or pan to be placed on the
cooking zone (pan recognition). Only when a pot has
been placed on the cooking zone will power be supplied.
The pot sign
pan was placed on the hob?
The cookware is unsuitable for induction cooking or the
pot or pan is too small.
Is the cookware you are using making noises?
This is due to technical reasons; the induction hob and
the pot are not at risk.
Does the cooling fan still operate after it has been
switched off ?
This is normal since the electronic unit is being cooled
down.
Is the hob making noises (clicking or cracking
sounds)?
This is for technical reasons and cannot be avoided.
Does the hob have tears or cracks?
There is a risk of electric shocks if the glass ceramic
plate develops fractures, cracks, tears or damage of
any other kind. Immediately switch off the appliance.
Disconnect the fuse immediately and call Customer
Service.
appears?
still appears, even though a pot or
GB