Accessories - ZUMEX SPEED PRO Série Manuel De L'utilisateur

COOLER UNIT (70)
Place the cooler unit in its housing in the stand (Figure 6).
Mount the components as indicated in Figure 19 in this order.
Mount the piston-gasket and the lever in the tank following the steps indicated in the
enclosed drawing.
Fit the tank.
Adjust the pump lid inside the tank with the arrow pointing towards you.
Secure the metal coupler plate, securing the tank with it.
SS/TANK STAND (90), COOLER STAND (100)
Machine placement on display stand:
IMPORTANT: This operation must be carried out by 2 or 3 people. It must never be attempted
by just one person.
Lock the front wheels of the stand with the brake pedal to prevent it from moving during the
installation.
After unpacking the stand, remove the screws from the fixing brackets and put them on one
side for later. See detail "A" of Figure 8.
The peel chutes and the drip tray of the stand with filter are located on the inside of the stand.
Place the machine on the stand, making the inside corners of the machine base coincide
with the two rubber blocks of the stand. Thus, the fixing bracket holes will coincide with
the machine holes. You can now secure the machine with the screws mentioned above (See
Figure 5 or 6).
Remember:
The machine and display stand are joined together with the screws supplied, as indicated in
this instructions manual.
Never try to tilt the machine or the stand. To move, unlock the wheels.
INDIVIDUAL FEATURES FOR SS/TANK STAND (90)
For the Self Service and Tank stands, secure the drip tray with its filter in the display stand.
If you have purchased a model with Drain&Clean System:
Important! Unplug the machine from the wall socket.
If fitted, remove the Peel chute (90.6), the SS stand filter (90.7A) and the Stand hopper (90.3)
(Figure 8). Open the front door (Figure 8).
Find the upper hole (Figure 7.2) and insert your hand, taking hold of the Flexible tube (80.4) and
placing it in the hole (Figure 7.1). Do not pull or hold any other part of the machine.
Later, place the lower cover of the tube with the two securing knobs supplied and fit all the
previously removed parts back on.
See parts breakdown on how to fit the components (Figure 8).
Component 90.7 varies depending on the stand model purchased:
Self Service stand: Component SS stand filter (90.7A).
Tank stand: Component TANK tank guides (90.7B).
The position of components Tray front (90.8) and Tray filter (90.9), can be adjusted to be able to
adapt them to different bottle and glass formats.
INDIVIDUAL FEATURES FOR COOLER STAND
See Figure 6 and 9.1 on how to fit the components correctly.
Pass the power cable of the Cooler unit through the hole on the rear door. To do this, you can
unscrew the door if necessary (Figure 9.2).
2. DETACHMENT
The components are detached in reverse order to that indicated in each section.

ACCESSORIES

Consult the different accessories you can attach to your machine on the Zumex website www.zumex.com.
You will find a wide range of accessories to configure your juicer according to your needs: Bottles, Bottle
Rack Kit, Self Service Tray Kit, Dynamic Cutting System, etc.
41